From: Michele Andreoli (m.andreoli@tin.it)
Date: Sat Jan 03 1998 - 17:08:31 CET
On Thu, Feb 10, 2000 at 08:25:00AM -0500, Chris Torry nicely wrote:
> Howdy, all.
>
> I am trying to install the mulinux 7r8 on a 486sx laptop with 4 meg of ram.
>
> When i boot with the disk, i get a message like
>
> "We need a swap"
> 1 to continue
> 2 to inspect the system
> 3 to abort
>
> How do I set up the swap? I am trying to get it to boot so that i can
> clone it to the HD. There is a preexisting
> swap partition, can i get it recognize
> that?
Newer release eat a little more ram; maybe, installing in 4M do not work.
Anycase, select 1). After that, muLinux ask for your DOS primary
hard-disk. It will use a SWAP-FILE, not a SWAP-PARTITION. A simple
file called linux.swp in c:\.
If your DOS disk is primary, /dev/hda1 will work.
If you get a lot of message "can't fork", you can't install muLinux:
the memory is too low for to complete the swap activation script :-(
In this case, reboot and chose solution 2), than proceed manually:
# I assume your DOS disk is /dev/hda1
#--------
# mount /dev/hda1 /swap
# dd if=/dev/zero of=/swap/linux.swp bs=1k count=8000
# mkswap /swap/linux.swp
# sync
# swapon /swap/linux.swp
This segment of code is extracted directly from /etc/rc.lowmem.
Ok, now we have a swap area in the DOS file c:\linux.swp.
(after istallation, please delete it).
We can start cloning:
# clone
This part of muLinux is very old, sorry. No enhancement had been made
for a while.
Have fun!
Michele
-- I'd like to conclude with a positive statement, but I can't remember any. Would two negative ones do? -- Woody Allen --------------------------------------------------------------------- To unsubscribe, e-mail: mulinux-unsubscribe@sunsite.auc.dk For additional commands, e-mail: mulinux-help@sunsite.auc.dk -----Multi-Part-Report-Level-1-1-13145--
This archive was generated by hypermail 2.1.6 : Sat Feb 08 2003 - 15:27:13 CET