From: Renato (renato@jfrj.gov.br)
Date: Mon Dec 06 1999 - 20:03:44 CET
Michele,
I had the same problem with X11 in 7r4b.
I configured mulinux the same way I did in previous versions.
When I enter 'startx' I see a black screen for about 5 seconds and then I'm back to the prompt with a message about log error file.
In all other previous versions the X Window ran nice and easy.
My eth card isn't detected by the system either. (even if I insmod the correct ethernet card module)
Fractured regards,
Renato Guimaraes
*********** REPLY SEPARATOR ***********
On 04/12/99 at 14:10 Michele Andreoli wrote:
>On Fri, Dec 03, 1999 at 09:28:32PM -0800, David LeBlanc nicely wrote:
>> Hi;
>> When trying to install networking, I get "no eth cards in system" and the
>> /setup/modules/ETHERNET_CARDS file is empty.
>>
>> I also got an "Interface: [a/c] option that had no explanation and the
>> second time I ran setup -f network, it only gave me the "c" option. Also on
>> the second run of setup, it did not ask me for an eth entry at all.
>
>[a/c]?? What's?
>
>>
>> X will now not run for me on 7r4B.
>>
>
>X run with the previous release?
>Can you to explain better what happen?
>
>Michele
>--
>I'd like to conclude with a positive statement, but I can't
>remember any. Would two negative ones do? -- Woody Allen
>
>
>---------------------------------------------------------------------
>To unsubscribe, e-mail: mulinux-unsubscribe@sunsite.auc.dk
>For additional commands, e-mail: mulinux-help@sunsite.auc.dk
---------------------------------------------------------------------
To unsubscribe, e-mail: mulinux-unsubscribe@sunsite.auc.dk
For additional commands, e-mail: mulinux-help@sunsite.auc.dk
This archive was generated by hypermail 2.1.6 : Sat Feb 08 2003 - 15:27:12 CET