Defining To Which SAP Systems User Data is
Replicated
Use
Use this procedure to define that user data is to be replicated to a particular system. You can define up to three systems.
Prerequisites
· The SAP System must have release 4.6D or higher.
· The user management property ume.replication.messaging.active is set to true. By default it is true.
Procedure
Open user management properties for editing
You define to which
systems user data is replicated in 
UME
Properties.
Specify the receiving systems
In UME Properties,
set the following property for each system to which you wish to
replicate:
ume.replication.adapters.index_<index>=xmladapter?adapterid=<adapterID>
<index>is a number between 1 and 3.
<adapterID> is an ID that uniquely identifies the system. Allowed values are 001, 002, and 003. This ID is used in all parameters relating to this system.
xmladapter specifies that replication is performed using XML documents. At present this part of the property value is always the same.
Specify the sending system and add it to ACL in SAP R/3 System
In UME Properties,
make sure the following property is set:
This property gives the system that is sending the replication data (in this case UME) a name. The default value is SAPMUM. When an XML document is sent to the SAP R/3 System, the SAP R/3 System performs a security check on the sender. If the sender is not in an access control list (SMUM_ACL table), the system returns an error.
In the R/3 System, open the table SMUM_ACL using transaction SM30 and add the sender name specified in the above property.
Define the system connection information for SAP Systems
In UME Properties,
define the properties as required for each SAP System to which you wish to
replicate data. You will find a complete list of the properties in SAP-System Data
Source. In all properties <adapterID> must be the same adapter id as you specified
in ume.replication.adapters.index_<index>.
Example
The following is an example of UME property values.
Property |
Value |
ume.replication.adapters.index_1 |
xmladapter?adapterid=001 |
ume.r3.sync.sender |
SAPMUM |
ume.r3.connection.001.client |
100 |
ume.r3.connection.001.user |
sapume |
ume.r3.connection.001.passwd |
<password> |
ume.r3.connection.001.sysnr |
38 |
ume.r3.connection.001.ashost |
server01.company.com |
ume.r3.connection.001.lang |
EN |
ume.r3.connection.001.poolmaxsize |
10 |
ume.r3.connection.001.poolmaxwait |
10000 |